Heavy duty dual bed roller brake tester for passenger cars, vans and light commercial vehicles. The RT2012 matches the capacity of the RT2002 and is a flush fitted dual roller brake tester with extra wide 900 mm rollers. It is the perfect solution for testing wider vehicles, trailers and caravans.

In addition to measuring the brake forces per wheel and the difference between the left and right sides, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel. Special attention has been given to prevent damage to the tires. The rollers are very quickly stopped when slippage occurs, even during the start-up of the motors. All roller brake testers are equipped with reliable worm gear motors. All moving components are supported by roller bearings for a long and trouble free service. The chassis are hot dip zinc.

A weighing system is available as an option. With this weighing facility, the deceleration (brake efficiency) of the vehicle will be calculated and can be compared with legal requirements for the service-, parking- and the emergency brake systems.

Optional:
Cover plates (hot dip zinc)
4-point weighing system (double set required)
Steel rollers

Free run roller set (hot dip zinc)
Overrun brake simulator
Tandem axle adaptor

	Specifications: Maximum axle load: 4 ton Roller speed: 5 km/h Brake force maximum: 8000 N Rollers: 206 x 900 mm Track: Variable Power supply: 2 x 5.5 kW; 3 phase, 400 V, 50 Hz Dimensions: 144 x 66 x 30 cm (one side) Chassis: hot dip zinc Motor voltage and frequency other than 3 phase 400 V / 50Hz are available upon request. Brochures: BD2060 Roller Brake Testers For Cars LD2071 Roller Brake Test Lanes For Cars Monitor Displays For Roller Brake Test Lanes For Cars